Kamis, 26 Mei 2011

How to Change Oil on a 2003 Harley FXD

How to Change Oil on a 2003 Harley FXD

How to Change Oil on a 2003 Harley FXDthumbnail
Change your Dyna's oil yourself and save money.

Regular oil and fluid changes are a part of the Harley-Davidson experience. Ensuring that your FXD Super Glide receives these oil changes will maintain its peak level of performance and extend its service life. While most FXD owners delegate this basic task to the capable hands of their local HD dealership, learning how to replace your bike's vital fluids can save you a great deal of money over the years. The process is fairly simple and can be done within an hour with the right tools.

Difficulty:
Moderate

Instructions

Things You'll Need

  • Oil pan
  • Allen key or socket set
  • Socket wrench
  • Shop towels
  • Drain plug O-rings (3)
  • Strap or oil filter wrench
  • Oil filter
  • Engine oil (3 Quarts)
  • Primary fluid (1 Quart)
  • Transmission fluid (1 Quart)
    • 1

      Drain the fluids from the motor. The engine oil drain plug is located at the forward, left-hand side of the motor's oil pan. The primary fluid drain plug is located directly under the primary derby cover. The transmission fluid drain plug is located under the right side of the motor. Place an oil pan under the plugs as you remove them with an Allen wrench or socket.

    • 2

      Wipe the drain plugs with a shop towel to remove any debris that may have accumulated on them and replace the drain plug O-rings. Reinsert the drain plugs and lightly tighten them with an Allen wrench or socket.

    • 3

      Place an oil pan directly below the engine's oil filter. Remove the oil filter with a strap wrench or an oil filter wrench and allow any remaining oil to drain. Discard the oil filter.

    • 4

      Fill the new oil filter with up to four ounces of fresh oil, and spread a thin coating of oil around the filter's mating surface with your finger. Screw the oil filter onto the motor by hand until it is seated against the motor. Add up to 2.5 quarts of engine oil into the oil tank.

    • 5

      Remove the primary derby cover with a Torx driver or Allen key. Pour up to one quart of primary fluid into the primary case. Hold the motorcycle upright and inspect the fluid level. The fluid should be level with the bottom of the clutch assembly. Replace the primary derby cover and tighten the mounting bolts with a Torx driver or Allen key.

    • 6

      Remove the transmission filler cap and pour up to one quart of transmission fluid into the filler neck. Replace the filler cap.

    • 7

      Wipe away any spills with a shop towel.

Tips & Warnings

  • Warm up the motorcycle for a few minutes and remove the filler caps to quicken the draining process.

  • Use only Harley-Davidson specified oil and fluid to prevent component failure caused by improper lubrication.

  • Do not attempt this task if you lack the necessary tools to complete the job. Instead, have the work performed by a qualified Harley-Davidson technician.

1 komentar:

  1. It is good that you know how to change the oil of your vehicle. However, if things get complicated and you think you can't handle it, just let the car expert do the task. Then, grab the chance to ask him about changing oils.

    Immanuel Llorens

    BalasHapus